MIL-S-64052
- Primer Coating, Epoxy
MIL-P-52192
- Thinner, Aircraft Coating
MIL-T-81772
STANDARDS
FEDERAL
- Screw-Thread Standards For Federal Services
FED-STD-H28
MILITARY
- Sampling Procedures and Tables for Inspection
MIL-STD-105
by Attributes
- Marking For Shipment and Storage
MIL-STD-129
- Identification Marking of US Military Property
MIL-STD-130
MIL-STD-889
- Dissimilar Metals
- Minimum Guidelines For Level C Preservation,
MIL-STD-1190
Packing and Marking
(Copies of specifications, standards, handbooks, drawings, and publications
required by contractors in connection with specific acquisition functions should
be obtiined from the contracting activity or as directed by the contracting
officer.)
(Nongovernment standards and other publications are normally available from the
organizations which prepare or which distribute the documents. These documents also
may be available in or through libraries or other informational services.)
2.2 Order of precedence. In the event of a conflict between the text of this
specification and the references cited herein (except for associated detail
specification specification sheets or MS standards), the text of this specification
shall take precedence. Nothing in this specification, however, shall supersede
applicable laws and regulations unless a specific exemption has been obtained.
REQUIREMENTS
3.
3.1 First article. When specified in the contract or purchase order, a sample
shall be subjected to first article inspection (see 4.2.l and 6.2.1).
3.2 Design and construction. The spray gun shall be a complete
functional assembly consisting of the gun, cup, gages, regulator, valves, gaskets,
"O" rings, bushings and seals. The spray gun shall be new and of the manufacturer's
current commercial design. The spray gun shall be designed for heavy duty
commercial/industrial production use. The spray gun shall be for hand held
operation and designed with an air pressure fluid material atomizing/mixing air cap.
The spray gun shall be designed for pressure feed. The spray gun shall be designed
and constructed to facilitate its complete disassembly and reassembly for cleaning
and repair using simple hand tools, without damaging the spray gun and all spray gun
component The spray gun shall contain no burrs, slivers, or galling of the
interior and exterior surfaces of the air and fluid passages before, during, and
after each disassembly and reassembly. The spray gun and its components shall be
constructed of materials which are chemically compatible with the coatings, enamels,
lacquers, paints, solvents and thinners encountered during life cycle use and
cleaning of the spray gun. Materials which are chemically compatible shall be those
materials that will not deteriorate or otherwise reduce life cycle operational
functions/characteristics. The internal orifice of the fluid nozzle shall be
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business