MIL-L-14576F
6.4 First article. When a first article is required, it shall be tested and
approved under the appropriate provision of the Federal Acquisition Regulation. The
first article should be a preproduction sample, or a standard production item from
the contractor's current inventory The contracting officer should include
specific instructions in all procurement instruments regarding arrangements for
examination, test and approval of the first article.
6.5 Safety and health requirements. In order that equipment integrated into the
user's operational environment will comply with OSHA limitations and control of
noise levels, radiation, electromagnetic emission, noxious vapors, heat, etc., as
applicable, specific requirements concerning such points of operation, and other
health and safety requirements, should be specified by the user.
6.6 Sampling. Sampling for quality conformance inspection should be in
accordance with MIL-STD-105, using Inspection Levels and Acceptable Quality Levels
( AQL ) as listed, unless 100 percent inspection is specified.
AQL
Inspection Level
Inspection or Test
l.O
II
Product examination (4.5)
---
100%
operational test (4.6.1)
---
Alignment test (4.6.2)
1.0
II
Commutator turning test (4.6.3)
1.0
II
Mica undercutting test (4.6.4)
4.0
s-4
Packaging inspection (4.7)
6.7 Subject term (key word) listing.
Mica undercut
Commutator
Armature
Lathe
6.8 Changes from previous issue. The margins of this specification are marked
with an asterisk to indicate where changes (additions, modifications, corrections
deletions) from the previous issue were made. This was done as a convenience only
and the Government assumes no liability whatsoever for any inaccuracies in these
notations. Bidders and suppliers are cautioned to evaluate the requirements of this
document based on the entire content irrespective of the marginal notations and
relationship to the previous issue.
Preparing activity:
Custodians:
Army - AL
Army - AL
Air Force - 99
project
NO.
49404588
Review activity:
Air Force - 82
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business